Edit an equipment event

  1. Select Equipment View.
  2. A grid showing the events recorded against equipment during the shift is displayed.

  1. Select the event you want to edit in the Events data grid:

Typically, the columns that are editable will be readily available in the data grid, while less important columns will be hidden. For the columns that can be edited, pick-lists are provided wherever possible to ensure that existing column values can only be replaced by valid values for that column.

The data grid allows you to view events sequentially, as they occurred during the shift. The ramifications of any changes you make to an event will be shown in subsequent events.

When you select an event in the grid, a complete summary of the event (all columns) is displayed as a Card view to the right of the data grid. The values that can be edited for the current event are highlighted in Bold. Column values that cannot be edited are shown as greyed-out.

When entering measures or other numeric data, validation is performed for that column.

You cannot edit the Date/Time of an event. However, you can delete an event and replace it with an event with a new date and time.

Truck Cycle events

Truck events record the (queue, load, haul and dump) cycle of truck events.

Certain rules apply specifically to truck events:

  • Trucks are always queuing at the loader they are assigned to, therefore the Queuing event is not editable.  

  • The Load attribute (material type) of a truck is pre-set. If no load attribute is assigned, the default attribute is the material type of the source location. The Load attribute is not editable.  In order to change the Loading attribute, add a set attribute event, or change the loader source location.

  • Truck departure or move-off events cannot be edited.

Add an equipment event

Delete an equipment event