Location Automatic Status Changes

This topic describes how to work with the following four location status change types:

  1. A measure is entered against a unit of equipment at the location.
  2. For example, a Charge up wagon reports that holes have been charged and the location status is set to: Ready to Blast. Or a Production drill enters its final measure and the location status is set to: To Charge.

    EntryOfMeasureAgainstEquipLR

  1. A measure is entered against the location.
  2. For example, a Development drill finishes at the face, calls-in the face holes drilled, and the location status is set to: Charging. Or a Charge up wagon finishes working on a face, calls-in the face charged measure, and the location status is set to: To Fire.

    EntryOfMeasureAgainstLocLR 

  1. An equipment unit is allocated to a location.
  2. For example, a Development drill is allocated to a location and the location status is set to: Drilling. Or a Shotcrete sprayer has been allocated to a location and the location status is set to: Spraying.

    EquipAllocatedToLocER

  1. An equipment unit is deallocated from a location.
  2. For example, a Bogger is deallocated from a face and the location status is set to: Bogged Out. Or a Charge up wagon leaves a location and the location status is set to: To Bolt.

    EquipDeallocatedFromLocER