EquipAllocatedToLocER
Automatic status change required: Whenever a truck is allocated to a loader location, its status is to be changed to Operating.
Reference data group: EquipAllocatedToLocER
Status Selection Mode:Automatic - No Prompt
In Pitram Portal applications and in Pitram Data Acquisition, an automatic status change to Operating will occur without prompting whenever a hauling truck is allocated to a loader location.
It is assumed that the necessary active lists have been established - for example:
| Active List | Items |
|---|---|
| Hauling Equipment | Haul1, Haul2 |
| Loading Locations |
LocA,LocB |
To define the status change in Reference Edit:
- Select Groups | Configuration Items | States | Equipment Status Rules | EquipAllocatedToLocER on the navigation pane.
- Select Checkout on the header.
- Click New EquipAllocatedToLocER on the workspace toolbar.
- In the Equipment Allocaation dialog, enter the following definitions:
| Option | Select |
|---|---|
| General | |
| Code | ALLOCATETRUCKTOLOC |
| Description | Allocate Truck to Load Location |
| Abbreviation | Allocate Truck to Load Location |
| Attribute | |
| Equipment* |
Hauling Equipment active list Select the appropriate active list from the list of Micromine Pitram | Equipment active lists. |
| Locations* |
Loading Locations active list This active list defines the list of locations that the unit has been allocated to. A hauling truck is currently at the Go Line, for example, and it has been allocated to one of the Op Loading Locations. |
| InitialEquipmentStates* |
Hauling States active list Select the active lists that itemises the possible initial equipment states. For example, an Idle status. |
| StatusSelectionMode* |
Automatic - No Prompt The status will change, without a prompt, whenever one of the trucks are allocated to one of the members of the OP Loading Locations active list. |
| ManualSelectionStates* |
Hauling States active list If the StatusSelectionMod is ManualSelection, the states listed in the selected active list will be presented. The Control Room Operator will manually select the appropriate status from this list. |
| AutomaticSelectionStatus* |
Operating If the StatusSelectionMode is any of the Automatic modes, Operating this is the status that will be applied to the unit of equipment. |
- Click OK to save your settings.
- Select Checkin on the header.
- Click Publish on the navigation pane header.
- In the Publish dialog, click Publish. You will receive a message to say that publishing has been successful. Click OK to close the message.
* Required attributes.
Wait till the version number of the reference edit group where you were working (EquipAllocatedToLocER) updates to the latest version.
In Data Acquisition
- Make sure the latest reference data version number is shown in the Status bar.
- On the Equipment tab of the Data Groups pane, set the filter to Hauling Equipment.
- Right-click on Haul1 and select Set Primary Status.
- Select Idle Time | Idle.
- Right-click on Haul1 and select Allocate to Location.
- Select Go Line. Haul1 is Idle at the Go Line while the operator is attending a shift meeting.
- After the shift meeting, Haul1 is instructed to go to LocA. Right-click and select Allocate to Location.
- Select Ore | LocA.
-
Has the status of Haul1 automatically changed to Operating?
Right-click on Haul1 and select Set Primary Status. It is now defined as Operating Time | Operating. Previously, the status was set to Idle