Troubleshooting Drill Data

The following table contains troubleshooting information on any issues that may occur with Mobile on the tablet, or the drill data in DOME.

What you see Why What to do
Tablet
"No Drill Data profile configured" The rig's unit configuration has no Drill Data Profile. Administrator sets DrillDataProfile on the rig's MobileUnitConfiguration and publishes reference data.
"No drill plan for this location" The ring the rig is allocated to has no published plan, or the plan has no Plan ID. Check the allocation is the right ring. In DOME check the plan is Published, not Unpublished, On hold or Complete. Wait for the tablet to synchronise.
Submit stays disabled No actual length entered, no measure selected, or the status is still Not started. Enter the length, pick a measure, set the status.
A parameter from the plan is missing The profile's parameter list does not include it, or its planned flag is off. Administrator adds the parameter to the profile's active list.
Holes drilled last shift show as not started The plan was replaced with a new Plan ID, or the retention period has passed, or the holes were submitted from a different tablet. Old actuals are still in reporting. Raise EventRetentionDays if rings outlive 62 days. Keep one tablet per rig where possible.
DOME
Import rejects a ring as published or complete Rings on a published or complete plan cannot be changed by import. Unpublish (or Reopen) the plan, import, then publish again.
Import rejects rows for a missing location or ring The file's location or ring does not match PITRAM, or the code/description switch is wrong. Fix the names in the file or tick the code/description option to match. For IREDES, map the positions to rings when asked.
Import rejects rows for a missing location or ring The file's location or ring does not match PITRAM, or the code/description switch is wrong. Fix the names in the file or tick the code/description option to match. For IREDES, map the positions to rings when asked.
Drill Plans screen is blocked PITRAM reference data could not be read. Wait for the reference data service and press Refresh.
Reporting
A hole shows no metres Its length did not change in the period, or the Measure criterion does not match the measure the driller picked. Widen the period or select the right measure code.

Drill Data