Reporting Drill Data

The Drillhole Actuals report in DOME Reporting shows, for a shift, every planned hole of the rings drilled, what was planned against what was drilled, and whether each ring is finished. It covers holes captured on the tablets and holes captured through older Carlson integrations alike. The report is available from Micromine Pitram version 17 and above.

To run the Drillhole Actuals report, in DOME,

  1. Open Reporting and select the Drillhole Actuals report.

  2. Set the criteria:

    • Period (the shift or shifts)

    • Equipment (the rigs)

    • Source (a location to get all its rings, or one ring), and

    • Measure (the drilled-metres measure, defaulted to the site's code).

  3. Click Run.

    The output is grouped by Shift, then Location, then Ring, then Hole. A single Shift is the usual run; a longer period repeats each ring under every shift it was drilled in.

Displayed in the report for each hole is the following:

Column Content
Plan ID, Location, Ring, Hole Where the hole is. Location is the ring's parent location.
Status Not started, Incomplete, Complete or Abandoned, as last set on the tablet.
Completed Time of day the hole was last submitted as Complete; blank otherwise.
Ad Hoc Yes for a hole added on the tablet (extra hole or redrill).
Planned and actual per parameter Length, Dip, Azimuth, Diameter and Breakthrough side by side. The column captions are the labels from the site's parameter reference data, so they match the tablet. Actual length is the metres drilled, summed from the measure events in the shift, net of any downward corrections.
Hole type From the plan; never has an actual.
Comment The hole's comments as last submitted, joined with a vertical bar (for example Void at 6 m | Water inflow).

Ring completeness

Each ring carries a summary derived from its rows: planned holes, and how many are complete, abandoned, incomplete and not started, plus a Ring complete flag that is true when every planned hole is Complete or Abandoned. Added holes are listed but not counted in the summary.

Two things to keep in mind when reading the report:

  • Status and completeness are current, not as at the shift. Running last week's shift shows the holes' status today; only the metres are per shift.

  • A hole whose metres did not change in the period (an abandoned hole at 0m, or a status-only resubmit) shows no metres for that shift.

     

For troubleshooting information on any issues that may occur with Mobile on the tablet, or the drill data in DOME, see Troubleshooting Drill Data.

Troubleshooting Drill Data