Truck Cycle Status Profile
| Attribute | Data Type | Description |
|---|---|---|
| Enable From Automation | 0 or 1 |
0. Disabled. 1. Enabled. Retroactively determine the loader when loading begins or when the cycle status changes. This is used in preference to cycle status from GPS if available. |
| Enable From GPS | 0 or 1 |
0. Disable. 1. Enable. Determines the truck cycle status from position. This will be used if Automation is disabled or not working. |
| Prompt For Loader On Load | 0 or 1 | Whether to prompt for a loader when being loaded but has not been allocated to a loader., |
| Prompt Method | 0, 1 or 2 |
0. Never prompt. 1. Prompt when ambiguous. 2. Never prompt. Defines the scenario of when to prompt if queuing for a loader. |
| Change Allocation On Queue | 0 or 1 | Whether of not a truck is allowed to change when it queues near a loader (Automation) or whether the truck is able to be considered for queuing for a loader that it stops next to, even if it has not already been allocated to it (for cycle status from GPS). |
| Change Allocation On Load | 0 or 1 | Whether of not a truck is allowed to change its allocation when begins loading near a loader (Automation), or whether the truck is able to be considered for loading at a loader it stops near to, even if it is not already allocated to it (for cycle status from GPS). |
| Stopped Moving Threshold Kph | N | Threshold speed, below which, trucks are considered to be stopped and above with are considered to be moving. |
| Min Travel Empty Time Before Queue | N | Minimum time, in seconds, that a truck must have been in the Travelling Empty portion of the cycle status before it is considered to be Queuing. |
| Dump Measure Code | T | Dump measure code used when submitting a dump even from GPS logic. |
| Dump Measure Value | N | Measure value used with submitting a dump event from GPS logic. |