EquipChangedStatusUnallocER

Automatic status change required: The carrier (the primary unit) has an emergency. All unallocated secondary units in the current active list are assigned an Idle status.

Reference data group: EquipChangedStatusUnallocatedER When a primary piece of equipment is allocated to a particular status (typically a Down status), the status of unallocated secondary equipment units that are part of the selected active list, is changed.

Status Selection Mode: Can be set to one of a series of automatic prompt states for status selection, or to manual selection.

To define the EquipChangedStatusUnallocatedER status change:

  1. Go to Groups | Configuration Items | States | Equipment Status Rules | EquipChangeStatusUnallocER on the navigation pane.
  2. Select Checkout on the header.
  3. Click New EquipChangeStatusUnallocER.
  4. Enter the Code, Description and Abbreviation for the new rule.

Enter the following definitions:

Attributes
PrimaryEquipment*This is the equipment that the rule applies to.
SecondaryEquipment*This is the name of an equipment active list that contains the secondary equipment that will have their status changed based on validation criteria.
Locations*This is the name of a location active list that contains the location the primary equipment must be allocated to for the rule to be executed
InitialEquipmentStates*This is the name of a status active list that the primary equipment must change to for the rule to be executed.
IncludeDownEquipmentThis flag indicates whether to change the state of a secondary equipment if it is in a down state.
IncludeIdleEquipmentThis flag indicates whether to change the state of a secondary equipment if it is in an idle state.
IgnoreOperatingEquipmentThis flag indicates whether to change the state of a secondary equipment if it is in an operating state.
ManualSelectionStates*The name of a status active list that contains the available states that can be submitted.
AutomaticSelectionStatus*The status that will be used when not selecting from a list of states as defined in the StatusSelectionMode attribute.
StatusSelectionMode*The Control Room Operator will select the appropriate status from the active list defined by ManualSelectionStates.

* Required attribute

StatusSelectionMode

Modes
Manual Selection The user of Data Acquisition is prompted with a dialog which allows them to select the status from a list defined by the active list in the ManualSelectionStates attribute.
Automatic Prompt The user of Data Acquisition is prompted with a dialog to confirm to submit the status as defined in the AutomaticSelectionStatus attribute.
Automatic No Prompt The status as defined in the AutomaticSelectionStatus attribute is automatically submitted against the equipment without any confirmation required from the user.
Automatic Conditional Prompt Not supported by the ECSU rule.