Editing
On the Wireframe tab, in the Editing group:
-
Click Copy to Active Layer (or right-click on the wireframes in Vizex and select Selection | Copy Wireframes to Active layer) to copy the selected wireframes to the active layer.
-
Select a Cut operation that will cut one or more selected wireframes. To define a cutting surface, one or more polylines or polygons are extruded in directions at right angles to the projection plane.
-
Select Cut Keep Inside from the Cut menu, to keep the wireframes that are situated inside the cutting surface. INSIDE = BELOW or RIGHT depending on the orientation of the surface.
-
Select Cut (Don't Close Solids) to cut selected wireframes using polylines or polygons. Resulting wireframes will assume the selected wireframe is open.
-
Click Buffer to create an outer or inner 3D shell at a fixed offset distance or buffer from a nominated wireframe.
-
Click Interactive Clip to clip a DTM (or a surface wireframe), using one or more polygons in Vizex.
-
Click Convert (Wireframe) to convert the coordinates in an input wireframe and optionally write the results to a second wireframe.
-
Select Convert Coordinates, to convert string or wireframe coordinates between two plane grids.
-
Click Move/Rotate to interactively move, copy, or rotate the wireframes you have selected in Vizex. Selecting this option will activate wireframe transform display mode.
-
Click Copy/Move Wireframes (or select Copy/Move Wireframe from the right-click menu) to copy or move selected wireframes by a specified amount.
-
Click Move (Shift) to move a wireframe a specified distance in a specified direction.
-
Click Separate to separate a triangulation into its constituent volumes or shells, depending on the separation mode selected.
-
Select Save As Single Wireframe (or select the same option from the right-click menu) to save the wireframes you have selected in Vizex as a single wireframe.
-
Select Save As Single to save the wireframes in a wireframe set as a single wireframe.
-
Click Save As Wireframe Set (or select the same option from the right-click menu) to save the wireframes you have selected in Vizex as a wireframe set.
